104
Advanced Setup – Part 1
Press the CURSOR
DD
or
HH
button to select the
“Exit”, then press the
ENTER button.
• The “System Setup Menu” reappears.
7
• “Base Curve Copy” is displayed after performing the Auto
Setup.
•To restore the settings to their defaults, select “Default Yes
0
”, then press the CURSOR
FF
button.
Procedure for copying the “Flat” correction
curve
1
Press the CURSOR
DD
button to select the “Base
Curve Copy”, then press the
CURSOR
FF
button.
2
Press the CURSOR
FF
button to select the “Yes”.
3
Press the ENTER button to enter the setting.
• The “Manual EQ” screen reappears.
The type of the copied correction curve is displayed in
the upper right of this screen.
• If the “Auto Setup” procedure has not been performed, this
item is not displayed.
To Next Page
Loading...
