Denon AVR-4806 - Basic Operation: Playing Sources; Playing the Input Source; Choosing Surround Sound Mode; Selecting the Room EQ Function

43
Basic Operation
Playing the input source
1
Select the input source to be played.
Example: CD
(Main unit) (Remote control unit) (Remote control unit)
To select the input source when ZONE2 SELECT,
ZONE3/REC SELECT or TUNING PRESET is selected,
press the SOURCE button on the main unit then operate
the input function selector.
SOURCE HOME THX
CINEMA
ROOM EQ
FUNCTION VOLUME
FUNCTION
SOURCE
ROOM EQ
VOLUME
HOME THX
CINEMA
SURROUND
2
Start playback on the selected component.
For operating instructions, refer to the component’s
manual.
3
Adjust the volume.
The volume can be adjusted within the range of –80 to
+18 dB, in steps of 0.5 dB. However, when the
channel level is set ( page 64, 65 or 116 ~ 118), if
the volume for any channel is set at +0.5 dB or greater,
the volume cannot be adjusted up to 18 dB. (In this
case the maximum volume adjustment range is “18 dB
— (Maximum value of channel level)”.)
(Main unit) (Remote control unit)
M.VOL. -80.0dB
The volume level is displayed on the master volume
level display.
2 To choose the surround sound mode
Example: THX Surround EX
Press the SURROUND button, then press the HOME
THX CINEMA
button.
For more information about the surround modes (
page 50, 51).
2 To select the Room EQ function
Press the ROOM EQ button.
For more information about the Room EQ function
( page 47).