57
Basic Operation
5
Press the CURSOR
DD
or
HH
button to select the
various surround parameters.
7
Press the ENTER or SURROUND PARAMETER
button to complete the setting.
6
Press the CURSOR
FF
or
GG
button to adjust the
parameters setting.
• When “Default” is selected and the CURSOR
FF
button is
pressed, “MODE” and “TONE” are automatically reset to
the default values and “CINEMA EQ.” is set to “OFF”.
• When playing PCM digital signals or analog signals in the
DOLBY PRO LOGIC
II, DOLBY PRO LOGIC IIx, DTS NEO:6
modes and the input signal switches to a digital signal
encoded in Dolby Digital, the Dolby Surround mode switches
automatically. When the input signal switches to a DTS
signal, the mode automatically switches to DTS surround.
2 Surround parameters t
DTS NEO:6 Mode:
• Cinema:
This mode is optimum for playing movies. Decoding is
performed with emphasis on separation performance to
achieve the same atmosphere with 2-channel sources as
with 6.1-channel sources.
This mode is effective for playing sources recorded in
conventional surround formats as well, because the in-phase
component is assigned mainly to the center channel (C) and
the reversed phase component to the surround (SL, SR and
SB channels).
• Music:
This mode is suited mainly for playing music. The front
channel (FL and FR) signals bypass the decoder and are
played directly so there is no loss of sound quality, and the
effect of the surround signals output from the center (C) and
surround (SL, SR and SB) channels add a natural sense of
expansion to the sound field.
CENTER IMAGE (0.0 to 1.0: default 0.3):
The center image parameter for adjusting the expansion of
the center channel in the DTS NEO:6 MUSIC mode has been
added.
DTS NEO:6 mode
• Surround playback can be performed for the analog input and
digital input 2-channel signals.
1
Press the STANDARD button to select the
“DTS NEO:6” mode.
• The DTS NEO:6 indicator lights.
The mode switches as shown
below each time the STANDARD
button is pressed.
lights
To Next Page
Loading...
Need help?
General
