Press the DIRECT/STEREO button to select the
STEREO mode.
2 STEREO mode
Use this mode to adjust the tone and achieve the desired
sound.
• The system setup function cannot be used when the PURE
DIRECT mode is set. To use the system setup function,
cancel the PURE DIRECT mode.
• If the HDMI input terminal is selected, video outputs are
outputted in the PURE DIRECT mode.
• The channel level and surround parameters in the PURE
DIRECT mode are the same as in the DIRECT mode.
Playing audio sources (CDs and DVDs)
2-channel playback modes
Press the PURE DIRECT button to select the PURE
DIRECT mode.
• The AVR-4806 is equipped with three 2-channel playback
modes exclusively for music.
• Select the mode to suit your tastes.
2 PURE DIRECT mode
This mode reproduces the sound with extremely high
quality. When this mode is set, all circuits and processes
not required for the selected input source (FL tube, video
circuit and tone control, as well as digital circuitry and other
unnecessary circuits for analog audio inputs) are
automatically turned off so the music signals can be
reproduced with high sound quality.
Press the DIRECT/STEREO button to select the
DIRECT mode.
The mode switches as shown below each time the
DIRECT/STEREO button on the main unit is pressed.
2 DIRECT mode
Use this mode to achieve good quality 2-channel sound. In
this mode, the audio signals bypass such circuits as the
tone circuit and are transmitted directly, resulting in good
quality sound.
To Next Page
Loading...
Need help?
General
