2 Parameters
MODE:
• DH1:
Reference room (small room with weak reverberations).
• DH2:
Live room (room with a bit stronger reverberations than
DH1).
• DH3:
Large room (larger room than DH1, offers a sense of
distance and sound diffusion effects).
• BYPASS:
Stereo sound.
DECODER:
Select this when playing analog, PCM or other 2-channel
sources.
The signals are converted into multichannel signals using
the decoders shown below and played in the Dolby
Headphone mode.
• PL
II C:
Dolby Pro Logic
II Cinema mode.
• PL
II M
Dolby Pro Logic
II Music mode.
• NEO:6 C:
DTS NEO:6 Cinema mode.
• NEO:6 M:
DTS NEO:6 Music mode.
• OFF:
The signals are played in the Dolby Headphone mode as
such (2 channels).
– Recording –
When RECOUT mode is set to “SOURCE”, with this
amplifier signals encoded in the Dolby Headphone mode
can be output from the recording output terminals and
recorded on another recorder ( page 85).
The Dolby Headphone
• The Dolby Headphone mode is set when headphones are
connected to the PHONES jack while in the DOLBY/DTS
SURROUND mode.
1
Press the SURROUND PARAMETER button.
• Display the “Surround Parameter” menu.
2
Press the CURSOR
DD
or
HH
button to select the
parameter.
3
Press the CURSOR
FF
or
GG
button to select the
setting.
4
Press the ENTER or SURROUND PARAMETER
button to complete the setting.
To Next Page
Loading...
