Denon AVR-4806 User Manual

72
Advanced Operation
OFF
ON
MODE SELECTOR
NUMBER
ENTER
Preset memory
• The included remote control unit can be used to operate
devices of different brands by registering the preset number
corresponding to the brand of your device.
For some models the remote control unit or the device may
not operate properly. In this case, use the learning function
( page 76) to store your device’s remote control signals
in the included remote control unit.
For instructions on resetting the preset memory ( page
78).
1
Press the ON and OFF button at the same time.
2
Press the 1 button to select preset memory.
2 Setup List
1: Preset memory
2: Learning setup
3: System call
4: Punch through
5: Light setup
6: Reset
3
Press the MODE SELECTOR button for the
component you want to preset, then press the
ENTER button.
Presetting is not possible for the AMP, ZONE2,
ZONE3, ZONE4, TUNER and D-TUNER modes.
3. Tuner system buttons
•, ª :Tuning up/down
BAND : Switch between AM and FM bands
MODE : Switch between AUTO and MANUAL
MEM :Preset memory
SFT : Switch preset channel range
CH +, – :Preset channel up/down
A ~ G :Preset channel range
1 ~ 8 :Preset channel
RDS :RDS search

Denon AVR-4806 Specifications

General

Brand	Denon
Model	AVR-4806
Category	Stereo Receiver
Language	English