Blitz-DT9 User Manual
- 58 -
Mode Map(SB)
1/3
1.Position-1：
2.Position-2：
3.Position-3：
Auto-Recovery
Gyro Off
Normal
If a 2-position switch is assigned to AUX1 channel, take SH switch as an
example, the interface is shown as below.
Mode Map(SH)
1/2
1.Position-1：
2.Position-2：
Auto-Recovery
Normal
If AUX1 channel is set to OFF, the interface is shown as the figure below.
Please return to Step 1 and reset the value of AUX1 channel.
Mode Map
AUX1 channel is OFF
NOTE: If AUX1 channel is set to OFF, the stabilized receiver works on
Normal mode.
(2) (The operation for 3-position switch) Roll the scroll wheel to select Position-1.
Press and then roll the scroll wheel to set the value. After that, press the scroll
wheel to save the value. Set the value of Position-2, and Position-3 in the
same way.
Position-1, Position-2, and Position-3 are respectively used to assign the
desired flight mode to position-1, position-2, and position-3. Values:
Gyro Off: Choose this mode to disable the gyros for all channels. The
airplane will be completely under the control of the transmitter. Generally, it
is only used to test.
Normal: In this mode, the gyro will sense angular velocity on each axis and
make a momentary reaction. The normal mode is suitable for all types of
To Next Page
Loading...
