4.3.1.6. IOLITE-GATE: Connection of IOLITE-R12 standalone device to IOLITE - single
channel and IOLITE - multi channel
Connect power supply cable to IOLITE-R12 (PS-120W-L1B2f).Then connect RJ45-RJ-45 cable to IN
connector of BUS 1 on IOLITE-GATE.
Use the RJ45-RJ45 cable to connect the IOLITE-R12 to IOLITE POWER-INJECTOR and then with an
additional RJ45-RJ45 cable to the IOLITE - single channel device. You need to connect the PS with the
cable to the IOLITE POWER INJECTOR.
Use the RJ45 to RJ45 cable again to connect the data line to IOLITE - multi channel device. The IOLITE -
multi channel device will need an additional Power supply.
Connection of IOLITE-R12, IOLITE - single channel and IOLITE - multi channel
IOLITE-R8 to IOLITE single channel: RJ-45 - RJ-45
IOLITE single channel to IOLITE multi channel: RJ-45 - RJ-45
To Next Page
Loading...
Need help?
General
