4.3.1.4. IOLITE-GATE: Connection of IOLITE-R12 standalone device to PC
First connect the power supply cable (PS-120-L1B2f) to the PWR IN 2-pin LEMO 1B connector. To increase
system reliability connect the redundant power supply to other PWR IN connectors.
Hint
To improve the redundancy of the system, it is recommended that the device is powered with
two power supplies connected to different electrical fuses!
Then connect a standard ethernet cable to the IN connector of BUS 1 on IOLITE-GATE. Finally, connect
the other side of the ethernet cable to the LAN port of PC.
Connection of IOLITE-R12 standalone device to PC
List of required cables:
To Next Page
Loading...
Need help?
General
