DGSHAPE monoFab SRM-20

To Next Page

To Previous Page

Contents

Creating a MODELA Player 4 File ............................. 70

STEP 1: Load the Cutting Data .......................... 70

STEP 2 : Set the Machine Selection ..................... 70

STEP 3 : Set the Origin Point of the

Model and Orientation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 71

STEP 4 : Set the Material ............................... 72

STEP 5 : Set the Number of Cutting Surfaces ............ 72

STEP 6 : Set the Margin ................................. 73

STEP 7 : Set the Surface leveling

Process of the Scrap Board ............................. 74

STEP 8 : Conrm the Cutting Preview ................... 81

STEP 9 : Set the Surface leveling

Process of the Material ................................. 83

STEP 10 : Set the Roughing Process ..................... 88

STEP 11 : Set the Finishing Process ..................... 93

STEP 12 : Set the Drilling Process ....................... 97

STEP 13 : Set the Bottom Surface Process ..............103

Cutting (Double Sided). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 105

STEP 1 : Attach the Material to the Scrap Board ........106

STEP 2 : Set the Origin Point ...........................108

STEP 3 : Perform the Surface Leveling

of the Scrap Board ....................................112

STEP 4 : Perform the Surface Leveling of the Material ..115

STEP 5 : Perform the Roughing .......................116

STEP 6 : Perform the Finishing .........................118

STEP 7 : Perform the Drilling in the Material ............120

STEP 8 : Perform the Drilling in the Scrap Board ........122

STEP 9 : Reverse the Material ..........................123

STEP 10 : Cut the Bottom Surface ......................126

STEP 11 : Remove the Cut Material ....................126

STEP 12 : Turning the Power O .......................127

http://www.dgshape.com/

Company names and product names are trademarks or registered trademarks

of their respective holders.

DGSHAPE monoFab SRM-20 - Page 3