Cutting (Double Sided)
47
STEP 3 : Perform the Finishing
The points to be checked before cutting
Check the following thing before starting cutting. If there are problems with
any of these, the cutting material may be wasted or the machine may be
damaged.
□ Is an output le right?
□ Have you made a mistake with the origin point position?
□ Do the cutting conditions match the type of cutting material?
To change the cutting tool for each process, replace the
cutting tool before outputting data.
"“STEP 5 : Attach the Cutting Tool” (p. 11)
〇〇●〇〇〇〇〇〇
To Next Page
Loading...