DGSHAPE monoFab SRM-20 - Guide for Cutting with SRP Player

Guide for Cutting with SRP Player
The Flow of Double-Sided Cutting ................15
The Flow of Double-Sided Cutting ..........................15
Items Necessary for Cutting .....................16
Items to Prepare Yourself ................................... 18
Preparing the Material..........................19
STEP 1 : Attach the Material to the Scrap Board .............19
STEP 2 : Install the Cutting Tool .............................21
STEP 3 : Set the Origin Point ................................22
STEP 4 : Level the Scrap Board Surface ......................26
STEP 5 : Perform the Surface Leveling of the Material ........28
STEP 6 : Level the Bottom Surface of the Material ...........30
Creating an SRP Player File ......................31
STEP 1 : Measure the Thickness of the Material ..............31
STEP 2 : Determine the Size and Orientation of the Model ...32
STEP 3 : Determine What to Do .............................35
STEP 4 : Create the Cutting Data ............................37
STEP 5 : Preview the Result of Cutting ......................40
Cutting (Double Sided) .........................41
STEP 1 : Set the Origin Point ................................41
STEP 2 : Perform the Roughing .............................42
STEP 3 : Perform the Finishing ..............................47
STEP 4 : Set the Drilling Process ............................52
STEP 5 : Drill the Scrap Board ...............................56
STEP 6 : Reverse the Material ...............................60
STEP 7 : Cut the Bottom Surface ............................62
STEP 8 : Remove the Cut Material ...........................63
STEP 9 : Turning the Power O .............................64