Cutting (Double Sided)
60
STEP 6 : Reverse the Material
Fix the material reversed using the positioning pin.
"“Reversal process using positioning pins” (p. 52)
Positioning pins (2)
1. Click the [View] button on the VPanel.
You may not be able to produce the desired product if the
movement worsens during the process because of built up
cutting waste. Keep an eye on how much cutting waste builds
up and, if deemed necessary, remove the cutting waste that
has built up around the X- and Z-axes. Also remove the cutting
waste that has collected in the dust tray.
2. Remove the cutting tool “2 mm Square.”
" “When changing to a cutting tool with the same shank diameter” (p. 13)
〇〇〇〇〇●〇〇〇
To Next Page
Loading...