SM 110 PROGRAM MODE
70
3.17 Place File
PLACE file is used for programming a short text describing the place of production. The number of
Characters possible to enter depends on the PLACE print area size and the character size used. Place
will be printed in the free room of Commodity Name print area if selected label format without Place
print area. Maximum 99 places (Place number 1 ~ 99) can be programmed, each with 1 line.
3.17.1 Program Place File
At Programming Mode, select Place programming mode and then enter new Place number (Ex. 1).
*For edit, enter existing Place number.
DISPLAY
OPERATION
PT kg
＄/kg ＄
REMARK
S1
→
PLU FILE Enter S mode.
[1][5][*] S15.0 PLACE 0 NO SET Enter Place File programming mode.
[1][*] S15.1 P01.01 S1 A100 Enter place file No.(Ex. No.1)
[M][A][D][E][SP]…… S15.1 P01.13 DIGI S1 A 88
Enter the Place File as the same
procedures as Commodity Name Entry.
(Ex. “MADE IN DIGI”)
[SIZE][SIZE]… S15.1 P01.13 DIGI S5 A 48
Change font size to S5.
(S1~S5; M1~M5; L1~L5)
[PLU] S15
→
PLACE FILE
Store Place File 1,back to S mode.
3.17.2 Delete Place File
At Place programming mode, enter existing Place Number (Ex. 1) to be deleted.
DISPLAY
OPERATION
PT kg
＄/kg ＄
REMARK
S15.0 PLACE 0 NO SET Enter Place File programming mode.
[1] S15.0 PLACE 1 NO SET Enter Place File number 1.
[－]
S15.0 FREE DEL ? Y-C N-T
Enter delete mode.
[C] for Yes,[T] for No.
[C] S15
→
PLACE FILE
Delete Place File 1, back to S mode.
Note1: If you want to cancel the deletion, press [T] key to exit.
Note2: Non-existing Place File can not be deleted.
To Next Page
Loading...
Need help?
General
