SM 110 PROGRAM MODE
79
3.22 Scroll Sequence File
Scroll Sequence # 1 to # 3 is available. Each scroll sequence consists of up to three kinds of Messages.
Scroll Sequence means the scroll display order and display appearance of the programmed scroll
message.
3.22.1 Program Scroll Sequence File
At Programming Mode, select Scrolling Sequence programming mode and then enter new Scroll
Sequence number (Ex. 1) programming mode. *For edit, enter existing Scroll Sequence Number.
DISPLAY
OPERATION
PT kg
＄/kg ＄
REMARK
S1
→
PLU FILE Enter S mode.
[1][4][*] S14.0 SC SQ 0 NO SET
Enter Scrolling Sequence
programming mode.
[1][*] S14.1 SC SQ MSG NO 000
Enter Scrolling Sequence file
number.(Ex. 1)
[1][2][3][*] S14.2 SC SQ ATTRIB 123 000
Enter existing Scrolling Message
Number.(Ex. 1, 2, 3)
[1][2][3][*] S14.2 SC SQ SPEED 123 000
Select Scrolling pattern for each
Scrolling Message.
(Ex. MSG#1=1, MSG#2=2 &
MSG#3=3)
[1][2][0] S14.2 SC SQ SPEED 123 120
Select Scrolling Rate.
(Ex.
MSG#1=1:NORMAL,MSG#2
=2:FAST and
MSG#3=0:SLOW)
[PLU] S14
→
SCROLL SEQUENC
Store the Scroll message 1 data,
back to S mode.
The scrolling pattern is as following.
0: L–SCROLL: Maximum100 characters
1: BLINKING: Maximum 25 characters
2: STATIS: Maximum 25 characters
3: R –SCROLL: Maximum100 characters
4: WIPE IN: Maximum 25 characters
To Next Page
Loading...
Need help?
General
