XBee® SX 868 RF Module User Guide
6
RTS flow control 57
Serial interface protocols 57
Transparent operating mode 57
API operating mode 58
Advanced application features
Remote configuration commands 60
Send a remote command 60
Apply changes on remote devices 60
Remote command responses 60
Network commissioning and diagnostics 60
Configure devices 61
Network link establishment and maintenance 61
Place devices 62
Device discovery 63
Link reliability 64
Commissioning pushbutton and associate LED 67
I/O line monitoring 69
I/O samples 69
Pin configurations 69
Periodic I/O sampling 72
Detect digital I/O changes 72
I/O line passing 73
Configuration example 73
General Purpose Flash Memory 75
Access General Purpose Flash Memory 75
General Purpose Flash Memory commands 76
Work with flash memory 82
Over-the-air firmware updates 82
Distribute the new application 82
Verify the new application 83
Install the application 83
Software libraries 84
Networking methods
Directed Broadcast/Repeater mode 86
Point to Point/Multipoint mode 86
Permanent (dedicated) 86
Switched 86
DigiMesh networking 86
DigiMesh feature set 87
Networking concepts 88
Device Configuration 88
Network ID 88
Data transmission and routing 88
Unicast addressing 88
Broadcast addressing 88
Routing 89
Route discovery 89
DigiMesh throughput 89
Transmission timeouts 90
To Next Page
Loading...
