Digi XBee SX 868 - Page 7

XBee® SX 868 RF Module User Guide
7
Modes
Transmit mode 93
Receive mode 93
Command mode 93
Enter Command mode 93
Troubleshooting 94
Send AT commands 94
Response to AT commands 95
Apply command changes 95
Make command changes permanent 95
Exit Command mode 95
Sleep mode 95
Force UART operation 96
Condition 96
Solution 96
Sleep modes
About sleep modes 98
Asynchronous modes 98
Synchronous modes 98
Normal mode 98
Asynchronous pin sleep mode 98
Asynchronous cyclic sleep mode 99
Asynchronous cyclic sleep with pin wake up mode 99
Synchronous sleep support mode 99
Synchronous cyclic sleep mode 99
Wake timer 100
Indirect messaging and polling 100
Indirect messaging 100
Polling 101
Sleeping routers 101
Sleep coordinator sleep modes in the DigiMesh network 101
Synchronization messages 101
Become a sleep coordinator 104
Select sleep parameters 106
Sleep immediate 106
Synchronous pulse 107
Start a sleeping synchronous network 107
Add a new node to an existing network 108
Change sleep parameters 109
Rejoin nodes that lose sync 109
Diagnostics 110
AT commands
Special commands 113
AC (Apply Changes) 113
FR (Software Reset) 113
RE (Restore Defaults) 113
WR (Write) 113
MAC/PHY commands 114
CM (Channel Mask) 114