C|24 Guide48
ChanWn (Channel Window Display) Determines
whether displaying plug-in or send parameters
opens the corresponding plug-in or send win-
dow on-screen in Pro Tools.
When this preference is set to “Yes,” the on-
screen display of plug-in and send windows
changes to reflect the state of the control
surface.
When this preference is set to “No,” the on-
screen display of plug-in and send windows does
not change to reflect the state of the control
surface.
2KbPan (Two-Knob Panning) (Pro Tools HD Only)
Toggles linking of front and rear pan controls in
surround panner windows to facilitate left-right
motion in the surround field.
Actions
(Pro Tools HD Only)
Prview (Preview) Puts Pro Tools in Preview
mode.
PchPrv (Punch Preview) Executes the Punch Pre-
view command.
SusPrv (Preview Suspend) Suspends Preview
mode.
Captre (Capture) Executes the Capture com-
mand.
PchCap (Punch Capture) Executes the Punch
Capture command.
Join Executes the Join command.
Automation Preferences
(Pro Tools HD Only)
AutoJn (Auto Join) Sets tracks in Latch mode to
automatically resume writing of automation af-
ter the transport is stopped and started again
during an automation pass.
LchStp (Allow Latch Prime in Stop) Toggles the
Allow Latch Prime in Stop preference, which al-
lows tracks in Latch mode to be primed for writ-
ing automation while the transport is stopped.
ColVCA (Coalesce when Removing Slaves from
VCA Group) Toggles the preference that auto-
matically coalesces automation to slave track
when they are removed from a VCA-controlled
group.
ColTrm (Coalesce Trim Automation) Sets the pref-
erence that determines when Trim automation
is coalesced. The preference settings are as fol-
lows:
• EveryP: After Every Pass
• OnExit: On Exiting Trim Mode
• Manual: Manually
To Next Page
Loading...
Need help?
General
