DigiDesign C24 User Manual

C|24 Guide66
Control Room Alt Outputs
The Control Room Alt Outputs can be trimmed
relative to the Main Output to compensate for
differences between speaker systems. The Left
and Right channels of the Alt Output can also be
trimmed relative to each other.
To trim the overall level of the Alt Outputs:
1 Hold the Alt Mon switch until the switch
flashes. The Trim amount appears in the right
side of the LCD displays. Available trim values
range from –30 dB to +6 dB, in 0.5 dB steps.
2 Turn the Control Room encoder to adjust the
Trim amount.
3 Press the flashing Alt Mon switch to confirm
the change, or press any other switch in the
Monitor section to cancel the change.
To trim the level for the Left or Right Alt Output:
1 Press the Alt Mon switch so that the Alt Mon
Output is selected (the switch it lit).
2 Hold the Left or Right Output Channel switch
until the switch flashes. The channel name and
Trim amount appear in the right side of the LCD
displays.
3 Turn the Control Room encoder to adjust the
Trim amount.
4 Press the flashing Output Channel switch to
confirm the change, or press any other switch in
the Monitor section to cancel the change.
Control Room Output Dim Function
The Dim switch applies an adjustable gain re-
duction to all Control Room monitor outputs.
The amount of Dim gain reduction can be set
while in any monitoring mode.
To set the amount of Dim gain reduction:
1 Hold the Dim switch until the switch flashes.
The Dim amount appears in the right side of the
LCD displays.
2 Turn the Control Room encoder to adjust the
Dim amount.
3 Press the flashing Dim switch to confirm the
change, or press any other switch in the Moni-
tor section to cancel the change.
Control Room Output Mono Function
The Mono switch sums the Left and Right Con-
trol Room outputs and lowers monitor output
by an adjustable amount. The amount of Mono
level reduction can be set while in any monitor-
ing mode.
To set the amount of Mono level reduction:
1 Hold the Mute switch until the switch flashes.
The Dim amount appears in the right side of the
LCD displays.
2 Turn the Control Room encoder to adjust the
Mono level reduction amount.
3 Press the flashing Mono switch to confirm the
change, or press any other switch in the Moni-
tor section to cancel the change.

DigiDesign C24 Specifications

General

Type	Control Surface
Channels	24
Compatibility	Pro Tools
Faders	24 motorized
Inputs	8 analog line inputs
Outputs	8 analog line outputs
Aux Sends	N/A (Control surface only)
Connectivity	Ethernet, MIDI
Display	LCD scribble strips
Power Supply	External power supply