Introduction
The projector can be controlled by using an external control system or a PC via an RS232 or LAN interface, using a terminal-emulation
program.
Network setup
1. Connect the projector to a LAN network.
2. Open the Setup > Network menu and edit network settings. The default IP address is 192.168.0.100 and the TCP port number is 7000.
Serial Port setup
• Baud rate 38,400 bps
• Data length 8 bits
• Stop bits one
• Parity none
• Flow control none
Notes
For details on connecting the
projector to an RS232 or LAN
network, see Control Connections
in the Connection Guide.
For details on changing network
settings, see Network in the
Operating Guide.
To Next Page
Loading...
Need help?
General
