Digital Projection Titan Super Quad Series - Information

Digital Projection Titan Quad / 800 / 930 Series APPENDIX D: MENU MAP Reference Guide
181
Rev H October 2013
Main Menu Sub Menus
Setup (continued)
System
Conguration PIP, Edge Blend
IR Address (slider, value range 0 ~ 99)
Feature Control
Shutter Open (command)
Shutter Close (command)
Power On (command)
Power Off (command)
Reset Default Settings (command)
Information
Lamps
Quad lamp models: Lamp 1 Hours, Lamp 1 Starts, Lamp 2 Hours, Lamp 2 Starts, Lamp 3 Hours, Lamp 3
Starts, Lamp 4 Hours, Lamp 4 Starts
Dual lamp models: Lamp 1 Hours, Lamp 1 Starts, Lamp 2 Hours, Lamp 2 Starts
Lamp Voltages
Quad lamp models: Lamp 1, Lamp 2, Lamp 3, Lamp 4
Dual lamp models: Lamp 1, Lamp 2
Conguration
Serial Number, Scaler, Interface, Hardware, Firmware, Factory ROM, OSD, Lens, 3D Hardware, 3D Firm-
ware, Sequences
Input
Standard
Control IP
LAN IP
Notes
Some of the information in this menu
map is summarised. See the actual
menu on the projector for full detail.
Do NOT reset the settings unless
you are sure that you want to restore
ALL the current settings to their
factory defaults.
3D conguration information is not
available with 2D projectors