DVR Server Manual
Off: The camera does not perform the exposure setting according
to the backlight situations.
Note:
When you set Normal or Spot in the backlight compensation, hunting
may be generated depending on the situations. In this case, set it to Off.
Exposure
【Camera ID】Checking this box allows you to superimpose the specified
characters. Enter up to 20 characters.
【Date Time】Checking this box allows you to superimpose the date and time.
【Style】Select the style of the superimposed item between Border and
Background.
【Position】Select the position of the superimposed item among Top-left,
Top-right, Bottom-left and Bottom-right.
【Sensor Input Mode】Specify the detection mode of the signal input to the
sensor input terminal of the camera.
Normally Open: Detects alarm when the sensor input is
short-circuited.
Normally Closed: Detects alarm when the sensor input is
open-circuited.
【Light Funnel Mode】Select Light funnel mode. There are 6 modes. However,
switch between normally open and normally closed is the most
commonly used.
Auto: Normally works in Light funnel off. It switches automatically
to Light funnel on in a dark place.
Timer: Set the Light funnel on/off using the timer.
【Threshold】Select High or Low for the brightness to switch the Light funnel
on.
【Hold Time】Select 2 sec. or 30 sec. for the response time to switch to the
brightness level.
【Status】Shows the current status of Light funnel function.
【Alarm Output NO.】The alarm output menu consists of two tabs: Alarm Out
1 and Alarm Out 2.
【Alarm Output Switch】Select whether alarm output or not.
【Alarm Output】Select the mode of the alarm output function.
Alarm: Controls alarm output synchronizing it with an external
sensor input or the built-in motion detection function. When
Alarm is selected, the items Sensor input, Motion
detection, Alarm duration and Effective period become
active.
Timer: Controls alarm output using the timer.
To Next Page
Loading...