DVR Server Manual
【Sensor Input】Select this option when you link the alarm output to an
external sensor that is connected to sensor input of the camera I/O
port.
【Motion Detection】Select this option when you link the alarm output to the
motion detection function.
【Alarm Duration】Select the duration for which the alarm output is short
circuited between 1 and 60 sec.
【Effective Period】This item becomes active when Mode is set to Alarm. Set
the period during which the alarm detection is effective.
Always: The alarm detection is always effective.
Schedule:
You can specify the period during which alarm
detection is effective. Click Schedule and the menu for the
effective period is displayed.
Trigger Alarm Output
【Trigger Alarm】Select the alarm output control mode from Toggle or Timer.
Toggle: Switch between On (short circuit) or Off (open).
Timer：By default, the alarm output is switched to On (short circuit),
and will automatically switched to Off (open) after the time
specified in Duration has elapsed.
【Voice Alert NO.】The Voice alert menu consists of 3 tabs: Voice alert 1,
Voice alert 2 and Voice alert 3. You can configure an individual
audio file on each tab.
【Voice Alert Switch】To use the voice alert function linked with the sensor
input or the motion detection function, select On.
【Voice Alert Repeat】Select playback repeat time from 1 to 3.
【Image Memory】To use the image memory function, select On.
【Built-in Memory】The current memory space of the built-in memory is
displayed.
【Over Write】Select On to overwrite the file or not when there is insufficient
memory space to record the image in the built-in memory.
On: Overwrite is enabled and old files will be overwritten in the
order of date.
Off: Overwrite is prohibited. No recording will be performed.
【Capacity Warning】Select On to send a warning mail to the Administrator
when the memory space of the built-in memory is low or the
memory is full. Select Off if you do not want to send a warning
mail.
Note:
When Overwrite is set to On, the warning mail will not be sent to the
Administrator.
【Alarm Recording】Select On to record the image and audio file in the
built-in memory linked with alarm detection.
【Image File Name】Type the file name you want to assign to the images to be
To Next Page
Loading...