DVR Server Manual
recorded. You can use up to 10 alphanumeric characters, -
(hyphen) and _ (underscore) for naming.
【Suffix】Select a suffix to be added to the file name.
【Sequence Number Clear】Click Clear to reset the Sequence number suffix
to 1.
【Alarm】Select the alarm to be linked with the recording of image and audio
files.
Sensor input: The external sensor that is connected to sensor
input of the camera I/O port.
Motion detection: The alarm by the motion detection function.
【Effective Period】Set the period during which alarm detection is effective.
Always: The alarm detection is always effective.
Schedule: You can specify the period during which alarm
detection is effective. Choose Schedule and the setting
menu for the effective period is displayed.
【Periodical Recording】Select On when you want to use periodical
recording.
【Periodical Mode】Select the periodical recording mode.
Periodical mode: An image file is recorded periodically according
to the specified Interval and Effective period.
Tour mode: An image file is recorded when the camera is moved
to each preset position during the tour.
Note:
You cannot record files in Tour mode while PTZ on motion detection is
performed.
【Periodical Interval】Type the interval at which you want to record an image
in the memory periodically. You can set the hour (H), minutes (M)
and seconds (S) between 1 second and 24 hours (one day).The
actual interval may be longer than the set value depending on the
image size, image quality, bit rate, or recording media.
Motion
【Threshold setting slider bar】Set the threshold level of motion detection
that is common to all the windows. The threshold level is used to
judge whether or not there has been any motion in the camera
image. When the motion of an object on the monitor screen has
exceeded the threshold level, the camera judges that there has
been a motion and a green frame is shown. An alarm is output
when a green frame is added to the object displayed in one of the
active windows.
【Object size】Select the minimum size of a detectable object. Select the
minimum size of a detectable object from L (Large), M (Medium)
and S (Small). Each option represents the corresponding size
below:
L: 64 × 64 dots
To Next Page