DVR Server Manual
【If use DNS to get IP】Select whether use DNS to get IP or not, if the
server end is the dynamic IP address, users need use DNS to get the server’s
IP.
【DNS Server IP】Set IP address of DNS server host.
【DNS Server Port】DNS server host’s port, which is provide to connect
DNS software.
When you finished adding IP Camera to DVR system, it will show the
status of that camera, including Sever name, IP Address, connect port,
sequence number for IP Camera, connect status and register information.
Note:
After you add IP cameras to DVR system, they will be collocated
sequence numbers after local board cards. The sequence numbers of the IP
cameras change dynamically according to the total numbers of local board
cards and the sequences of the IP cameras that have been added to DVR
system. For example, if there are 32 channels local board cards, then you add
2 IP cameras. They will be collocated 33 and 34 as their sequence numbers.
Then if you add another board card (4 channels), the sequence numbers of
them will change to 37 and 38 dynamically.
(2). Modify IP camera
Press button to modify IP camera’s information, its interface is
same as Add IP Camera.
(3). Delete IP camera device
Press button to delete connected server. When system is in
To Next Page
Loading...