Entrematic Canada Inc.
Toll Free: 1-877-348-6837
info.ditec.ca@entrematic.com
www.ditecentrematic.ca
Entrematic USA Inc.
Toll Free: 1-866-901-4284
info.ditec.us@entrematic.com
www.ditecentrematic.us
Place arm on unit at center line of unit. Then rotate the arm -5° (while holding the unit) so you can
remove the two screws that hold the Lock Kick / Stop Block Assembly. The Arm is under spring load
so do not release. After removing Lock Kick / Stop Block Assembly allow the arm to gently rotate to
remove the spring load.
Reinstall the Lock Kick / Stop Block Assembly in the alternate location (180° from its original position).
2.0 OPERATOR INSTALLATION
To Next Page
Loading...
