Entrematic Canada Inc.
Toll Free: 1-877-348-6837
info.ditec.ca@entrematic.com
www.ditecentrematic.ca
Entrematic USA Inc.
Toll Free: 1-866-901-4284
info.ditec.us@entrematic.com
www.ditecentrematic.us
3.2 Push Arm Installation
STEP 1
Keep the door in close position,
Install Door Shoe 9 ⅜” (238mm) to first hole from hinge
side, the second hole 2 ½” (64mm) from the first. For
push arm configuration option 1 both the holes are
located at 2 ⅞” (73mm) from the bottom of header and 3
⅞” (98mm) for option 2.
Attached Rod to door block. Fit Main Handle and
Sleeve on drive shaft (spindle) at 80 degrees to the
door latch.
STEP 2
Line up Rod with Sleeve and mark 1” (25mm) past 2nd
set screw and cut
Remove Main Handle from drive shaft (spindle),
and insert Rod fully into Sleeve. Tighten set screws.
STEP 3
Set Operator Switch to Automatic and allow door to close
under spring pressure. Test and adjust if necessary.
WARNING!
Please ensure Shoe Bolts at these joints are tightened after installation of arm is complete.
To Next Page
Loading...
