________________________________________________________________________________________________________
1592025400 – Vers. 1.0 - 73 -
8.4.3 File PARAM
The file param.txt is the list of parameters for iPRO.
Create a standard txt file with the following structure:
0=value
1=value
.........
9=value
The meaning of 0,1,2, etc is :
0=IP Address 1=HOSTNAME
2=DNS 3=DOMAIN
4=Modbus Address 5=NETMASK
6= NET 7=Net Gateway
9=MODSLAVE_Parameters
The files can be transfer to the iPRO using the USB; at the end the iPRO will reboot
automatically with the new configuration. (It is not necessary to write all the parameters).
8.4.4 File SPALT
The spalt files are files necessary to program the iPRO to send e-mail and sms.
These file are:
• Default.spalt
this file includes the default parameters to configure the modem. You can change:
ANALOG_ENABLE_DIAL_IN = 1: enable 0: disable
ANALOG_RESET = intmodem/intreset if iPRO has internal modem
extmodem/extreset if iPRO has external modem
ANALOG_LOCAL_IP = iPro’s IP during the dial-in.
To debug in dial-in mode:
change IP address in ISaGRAF – (through ISaGRAF Network Architecture)
compile
select debug
To Next Page
Loading...
