dji INSPIRE 3 - FAR Remote ID Compliance Information

DJI Inspire 3 User Manual
142
©
2023 DJI All Rights Reserved.
Regulatory Restricted Zones
Due to local regulations and policies, ights are prohibited within the scope of some special
areas. (Example: Prisons)
Approved Zones for Light UAVs (China):
For Approved Zones, pilots of light UAVs ying at an altitude of 120 m or less are not required to
obtain permission to y. Pilots who are planning to y medium-sized UAVs in Approved Zones
at an altitude higher than 120 m, or in GEO Zones other than Approved Zones, must obtain
permission via UTMISS before taking o.
UGZ Zone for Geo-awareness function
EASA Notice
Make sure to read the Drone Information Notices document included in the package before
use.
Go to the address below for more EASA notice information for traceability.
https://www.easa.europa.eu/en/document-library/general-publications/drones-information-
notices
Original Instructions
This manual is provided by SZ DJI Technology, Inc., and the content is subject to change.
Lobby of T2, DJI Sky City, No. 53 Xianyuan Road, Xili Community, Xili Street, Nanshan District,
Shenzhen, China, 518057.
FAR Remote ID Compliance Information
The aircraft complies with the requirements of 14 CFR Part 89:
• The aircraft automatically initiates a pre-flight self-test (PFST) of the Remote ID system
before takeo and cannot take o if it does not pass the PFST
[1]
. The results of the PFST of
the Remote ID system can be viewed in a DJI ight control app such as DJI Pilot 2.
• The aircraft monitors the Remote ID system functionality from pre-ight to shut down. If the
Enhanced Warning
Zone
(EU UGZ Zones)
220 m
40 m
1. UA can take off and fly into EU UGZ
Zones and its nearby area with a
warning message
Nearby area