dji INSPIRE 3 - Remote Controller Charging and Battery Check

DJI Inspire 3 User Manual
74
©
2023 DJI All Rights Reserved.
Charging the Remote Controller and Checking the Battery Level
Charging the Remote Controller
Read the Using the Charging Hub section for more information. It takes approximately 2 hours
to fully charge the remote controller internal battery.
• It is recommended to use the charging hub for charging. Otherwise, use a certified
USB-C charger with a maximum rated power of 65 W and maximum voltage of 20 V
such as the DJI 65W Portable Charger.
• Fully discharge and charge the remote controller every three months. The battery
depletes when stored for an extended period.
• If a WB37 battery is installed in the remote controller, the WB37 battery will be charged
at the same time.
• The remote controller cannot be powered on before activating the internal battery.
• Make sure to use the included USB-C to USB-C high-speed data cable for optimal
charging.
Charging Options
A. The internal battery of the remote controller can be charged with a charging device or
the inserted external WB37 battery. It takes approximately two hours to fully charge the
internal battery with a charging device. The internal battery can be charged up to 50% with
the external battery. Charging with the external battery is not possible after the remote
controller is powered o.
B. Duration for fully charging a WB37 battery with 0% power:
a. When mounted on the remote controller and the internal battery level is 0%, it takes
approximately 2 hours while fully charging the internal battery.
b. When mounted on the remote controller and the internal battery level is 100%, it takes
approximately 1 hour and 10 minutes.
• The charging time may vary with the ambient temperature.
Charging Mechanism
A. When the remote controller is connected with both a charging device and an external
battery, the remote controller will be powered by the charging device.
B. When the external battery is mounted and the remote controller is not connected with a
charging device, the remote controller will be powered by the external battery. When the
external battery is depleted, the remote controller will be powered by the internal battery.
Checking the Battery Level
Checking the Internal Battery Level
Press the power button once to check the current battery level.