To Next Page

To Previous Page

DJI Inspire 3

User Manual

Aircraft Indicators

The aircraft has front LED, rear LED, and Y-shape LED indicators.

1. Front LED Indicators

2. Rear LED Indicators

3. Y-shape LED Indicator

When the aircraft is powered on but the motors are not running, the front LEDs glow solid red

to display the orientation of the aircraft.

When the aircraft is powered on but the motors are not running,

the rear LEDs display

the status of the ight control system. Refer to the table below for more information about the

aircraft status indicators.

Normal States

Blinks red, yellow, and green

alternately

Powering on and performing self-diagnostic

tests

×4 Blinks yellow four times Warming up

Blinks green slowly GNSS enabled

×2 Blinks green twice repeatedly Vision systems enabled

Blinks yellow slowly

GNSS and vision systems disabled (Attitude

mode enabled)

Warning States

Blinks yellow quickly Remote controller signal lost

Blinks red slowly Low battery level, takeo is disabled *

Blinks red quickly Critically low battery

Blinks red quickly (when

performing CSC)

IMU error

—

Solid Red Critical error *

Blinks red and yellow

alternately

Compass calibration required

* If the aircraft cannot takeoff while the rear indicator is blinking red slowly or solid red, connect to the

remote controller, run DJI Pilot 2, and view the details.

1 2

Other manuals for dji INSPIRE 3

Questions and Answers:

Need help?

Do you have a question about the dji INSPIRE 3 and is the answer not in the manual?

General

Camera Sensor	Full-Frame CMOS
Obstacle Sensing	Omnidirectional
Max Ascent Speed	8 m/s
Max Descent Speed	8 m/s
Internal Storage	1 TB SSD
Gimbal	3-axis (tilt, roll, pan)
Camera	Zenmuse X9-8K Air
Effective Pixels	24 MP
Gimbal Stabilization	±0.01°
Transmission System	DJI O3 Pro
Live View Quality	1080p/60fps
Remote Controller	DJI RC Plus
Remote Controller Charging Port	USB-C
Flight Time	28 minutes
Transmission Range	15 km
Max Speed	94 km/h
Operating Temperature	-20°C to 40°C
GNSS	GPS + Galileo + BeiDou
Operating Frequency	2.4000-2.4835 GHz; 5.725-5.850 GHz
Transmitter Power (EIRP)	2.4 GHz: <33 dBm; 5.8 GHz: <33 dBm
Hovering Accuracy Range	Vertical: ±0.1 m; Horizontal: ±0.3 m
ISO Range	Video: 100-25600
Shutter Speed	1/8000s to 2s
Supported File Formats	JPEG, DNG, MP4, MOV
Latency	90 ms
Remote Controller Operating Frequency	2.4000-2.4835 GHz; 5.725-5.850 GHz
Supported SD Cards	microSD
Video Resolution	8K