dji INSPIRE 3 - Warming the Battery

DJI Inspire 3 User Manual
©
2023 DJI All Rights Reserved.
55
Warming the Battery
The battery has a built-in self-heating feature for when operating in low-temperature conditions:
1. When the battery temperature is lower than 18° C (64.4° F), self-heating starts once the
battery is inserted into the aircraft and powered on.
2. If the battery is not inserted into the aircraft, press and hold the battery level button for ve
seconds to initiate self-heating. The battery will continue to keep warm with a temperature
between 18° and 20° C (64.4° and 68° F) for approximately 30 minutes. Press and hold the
battery level button for ve seconds to stop self-heating.
3. If the battery is at a temperature below 10° C (50° F), the charging hub will warm up the
battery once it is inserted in the powered-on charging hub.
4. When the battery is warming up and staying warm the battery level LEDs will blink as follows.
• At a temperature below 10° C (50° F), battery resistance increases and voltage
decreases signicantly, which in turn reduces battery capacity and performance. Make
sure that the battery is fully charged and the cell voltage is 4.4 V before use.
• When the DJI Pilot 2 app shows a critically low battery level warning, it is recommended
to stop ying immediately and land the aircraft in an appropriate place. During auto
landing, users can still use the remote controller to control aircraft orientation and push
the throttle stick to lift the aircraft.
• In extremely cold temperatures, the battery temperature may not be high enough for
it to operate, even after warming up. In such scenarios, increase the insulation of the
battery.
• To ensure optimal performance, keep the temperature of the batteries above 18° C
(64.4° F) before ight.
• In low temperatures, the preheating period may be longer. It is recommended to
insulate the batteries in advance to shorten the preheating period.
Warming up Keeping warm