To Next Page

To Previous Page

118

MATRICE 30 SERIES User Manual

Using DJI Assistant 2 (Enterprise Series)

DJI Assistant 2 (Enterprise Series) supports the updating of the remote controller and aircraft but not the

BS30 battery station. Please use the DJI Pilot 2 app to update the battery station.

Aircraft and Remote Controller

1. Connect the remote controller or aircraft to the PC one by one, as the assistant software does not

support the updating of multiple DJI devices at the same time.

2. Make sure the PC is connected to the internet and the DJI device is powered on with a battery level

higher than 25%.

3. Run the assistant software, log in with your DJI account and enter the main interface.

4. Tap the rmware update button on the left side of the main interface.

5. Select the rmware version and tap to update. The assistant software will download and update the

rmware automatically.

6. When the "Update successful" prompt appears, the device update is completed, and the DJI device

will restart automatically.

The battery rmware is included in the aircraft rmware. Be sure to update the rmware of all

batteries.

For the rmware update process, the battery levels of the aircraft and remote controller must

be higher than 25%.

Make sure all DJI devices are connected to the PC properly during an update.

During the update process, it is normal for the gimbal to go limp, the aircraft status indicators

to blink, and the aircraft to reboot. Wait patiently for the update to complete.

Make sure to keep the aircraft away from people and animals during a firmware update,

system calibration or parameter conguration.

For safety, make sure you are using the latest rmware version.

After the rmware update is completed, the remote controller and the aircraft may become

disconnected. Re-link them if necessary.

During a rmware update, DO NOT insert or remove the batteries to avoid battery update

failure.

During a rmware update, DO NOT unplug the USB-C cable to avoid rmware update failure.

Oline Update

An oine rmware package can be downloaded from the DJI ocial website to an external storage

device such as a microSD card or U disk. Run DJI Pilot 2, tap HMS, and then Firmware Update. Tap

Oine Update to select the rmware package of the remote controller, aircraft, or battery station from

the external storage device and tap Update All to update.

dji M30 T User Manual

Other manuals for dji M30 T