74
©
2022 DJI All Rights Reserved.
MATRICE 30 SERIES User Manual
Warnings
1. Keep liquids away from the inside of the battery station.
2. DO NOT close the cover of the battery station during charging. Make sure it is well-ventilated and
able to dissipate heat.
3. The battery station is only compatible with the TB30 battery and WB37 battery. DO NOT use the
battery station with any other battery models.
4. Place the battery station on a at and stable surface when in use. Make sure the device is properly
insulated to prevent re hazards.
5. DO NOT attempt to touch the metal terminals in the battery station. Clean the metal terminals with a
clean, dry cloth if there is any noticeable buildup after powering o.
6. Take care to avoid injuring your ngers when opening or closing the battery station.
Using the Battery Station
Chaging
1. Connect the battery station to a power outlet using the AC power adaptor cable.
2. Press the power button once to power on the battery station.
3. To charge the DJI RC Plus remote controller, connect the USB-C ports of the battery station and
remote controller using a USB-C to USB-C cable.
4. For TB30 batteries, make sure the charging mode is set to the mode required. The charging time is
shown in the diagram.
Storage Mode: Each battery pair is charged to 50% in sequence and kept at 50% after charging. *
Ready-to-Fly Mode: Each battery pair is charged to 90% in sequence and kept at 90% after
charging. *
Standard Mode: Each battery pair is charged to 100% in sequence.
* The battery station should be powered on to maintain the battery level in Storage Mode and Ready-to-Fly
Mode. Power o the battery station after charging, except for special situations such as re emergencies.
Maintaining high power level in Ready-to-Fly Mode will aect battery life.
To Next Page
Loading...
Need help?
General
