To Next Page

To Previous Page

MATRICE 30 SERIES User Manual

Hot Battery Replacement

After landing, the aircraft does not have to be powered o for replacement of its batteries. First, insert a

fully charged battery and wait for three seconds before inserting another battery.

Warming the Battery

The battery has a built-in self-heating feature for when operating in low-temperature conditions:

1. When the battery temperature is lower than 18° C (64.4° F), self-heating starts once it is inserted into

the aircraft and powered on. Self-heating will turn o automatically after aircraft takeo. When the

battery temperature is lower than 10° C (50° F), the aircraft will not take o. Wait until the battery is

warmed up before operating the aircraft.

2. If the battery is not inserted in the aircraft, press and hold the battery level button for 5 seconds to

initiate self-heating. The battery will continue to keep warm with a temperature between 15° and

20° C (59° and 68° F) for approximately 30 minutes. Press and hold the battery level button for 5

seconds to stop self-heating.

3. If the battery is at a temperature below 10° C (50° F), the battery station will warm up the battery

once it is inserted in the powered on battery station.

4. The battery level LEDs will blink as follows when the battery is warming up and keeping warm.

Warming up Keeping warm

Notes for operating at low temperatures

1. At a temperature below 10° C (50° F), battery resistance increases and voltage decreases

signicantly, which in turn reduces battery capacity and performance. Make sure that the battery is

fully charged and the cell voltage is 4.4 V before use.

2. When the aircraft is in ight after the above conditions are satised, and the DJI Pilot 2 app shows a

critically low battery level warning, it is recommended to stop ying immediately and land the aircraft

in an appropriate place. During auto landing, users can still use the remote controller to control the

aircraft’s orientation. For example, users can push the throttle stick to lift the aircraft.

3. At extremely cold temperatures, the battery’s temperature may not be high enough for it to operate

even after warming up. In such scenarios, increase the insulation of the battery.

4. To ensure optimal performance, keep the temperature of the batteries above 18℃(64.4° F) before

ight.

5. At low temperatures, the preheating period may be longer. It is recommended to insulate the

batteries in advance to shorten the preheating period.

dji M30 T User Manual

Other manuals for dji M30 T