45
©
2022 DJI All Rights Reserved.
MATRICE 30 SERIES User Manual
Aircraft RTK
RTK Module Introduction
The built-in RTK module of the aircraft can withstand strong magnetic interference from metal structures
and high-voltage lines, ensuring safe and stable flights. When used with a D-RTK 2 High Precision
GNSS Mobile Station for Matrice Series (excluded) or a DJI-approved Network RTK service, more
accurate positioning data can be obtained.
Enabling/Disabling RTK
Ensure that the RTK function is enabled and RTK service type is correctly set (D-RTK 2 Mobile
Station or Network RTK) before each use. Otherwise, RTK cannot be used for positioning. Go to
the camera view in the DJI Pilot 2 app, tap and then select to check the settings. Make
sure to disable the RTK function if not in use. Otherwise, the aircraft will not be able to take off
when there is no differential data.
RTK positioning can be enabled and disabled during flight. Remember to select an RTK
service type rst.
After RTK is enabled, Maintain Positioning Accuracy Mode can be used.
D-RTK 2 High Precision GNSS Mobile Station for Matrice Series
1. Refer to the D-RTK 2 High Precision GNSS Mobile Station User Guide (available from https://www.
dji.com/matrice-30/downloads) to set up the D-RTK 2 Mobile Station and link the aircraft and the
station. Power on the D-RTK 2 Mobile Station and switch to the Broadcast mode for the M30 Series.
2. In the RTK settings in the app, select “D-RTK 2 Mobile Station” as the RTK service type, connect
to the mobile station by following the on-screen instructions, and wait for the system to search for a
satellite. When the status of the aircraft’s positioning in the status table shows “FIX”, it indicates that
the aircraft has obtained and used dierential data from the mobile station.
3. D-RTK 2 Mobile Station communication distance: 12 km (CC/FCC), 6 km (SRRC/CE/MIC).
Network RTK
To use Network RTK, make sure that the remote controller has a Wi-Fi connection. Instead of the
D-RTK 2 Mobile Station, Network RTK can be used to connect to an approved Network RTK server
for receiving and sending dierential data. Keep the remote controller turned on and connected to the
internet when using this function.
1. Make sure that the remote controller is connected to the aircraft and the internet.
2. Go to the camera view in the DJI Pilot 2 app, tap and then select . Select “Network RTK” as
the RTK service type, then select “Purchase a Network RTK plan” and tap “Purchase a plan”. Follow
the on-screen instructions to purchase and activate the plan. DJI has provided a Network RTK plan
to you. Follow the above steps to activate the plan within the validity period. If the provided plan has
expired, please purchase an additional Network RTK plan. You can also use Custom Network RTK
(make sure that the remote controller is connected to the internet).
3. Wait to connect to the Network RTK server. In the RTK settings, when the status of the aircraft’s
positioning in the status table shows “FIX”, it indicates that the aircraft has obtained and used
dierential data from Network RTK.
To Next Page
Loading...
Need help?
General
