31
©
2022 DJI All Rights Reserved.
MATRICE 30 SERIES User Manual
Pre-Flight Checklist
The pre-ight checklist can be used as a reference for pre-ight check in daily operations.
1. Make sure the remote controller and the aircraft batteries are fully charged, the TB30 batteries are
installed rmly, and the battery release toggles are locked.
2. Make sure the propellers are securely mounted and not damaged or deformed, that there are no
foreign objects in or on the motors or propellers, that the propeller blades and arms are unfolded,
and that the frame arm folding buttons are popped out in the locked position.
3. Make sure the lenses of the vision systems, cameras, FPV, the glass of the infrared sensors, and the
auxiliary lights are clean and not blocked in any way.
4. Make sure the gimbal is unlocked and the camera is facing the front of the aircraft.
5. Make sure the covers of microSD card slot, the PSDK port, and the dongle compartment have been
closed rmly.
6. Make sure the remote controller antennas are adjusted to the proper position.
7. Power on the aircraft and the remote controller, toggle the flight mode switch to N-mode. Make
sure the status LED and the aircraft authority button on the remote controller are solid green. This
indicates that the aircraft and the remote controller are linked and the remote controller is in control of
the aircraft.
8. Place the aircraft on open and flat ground. Make sure there is no obstacles, buildings, or trees
nearby, and that the aircraft is 5 m away from the pilot. The pilot should be facing the rear of the
aircraft.
9. To ensure ight safety, enter the ight view of DJI Pilot and check the parameters on the pre-ight
checklist such as the control stick mode, RTH height, obstacle distance, and failsafe settings. It is
recommended to set the failsafe action to RTH.
10. Divide the airspace for ight when multiple aircraft are operating simultaneously in order to avoid
collision mid-air.
To Next Page
Loading...
Need help?
General
