70
©
2022 DJI All Rights Reserved.
MATRICE 30 SERIES User Manual
Calibrating the Compass
The compass may need to be calibrated after the remote controller is used in areas with electromagnetic
interference. A warning prompt will appear if the compass of the remote controller requires calibration.
Tap the warning prompt to start calibration. In other cases, follow the steps below to calibrate the
remote controller.
1. Enter the home screen.
2. Open Settings, swipe up, and select Compass.
3. Follow the diagram on the screen to calibrate the remote controller.
4. The user will receive a prompt when the calibration is successful.
If the remote controller compass is working normally, "Calibration Success" will be prompted
after entering the calibration view. It is not necessary to perform the calibration.
HDMI Settings
The touchscreen can be shared with a display screen via an HDMI cable. The resolution can be set in
Settings, Display, Advanced, and then HDMI.
Advanced Dual Operator Mode
M30 series aircraft support Advanced Dual Operator mode that allows two pilots to operate an aircraft
simultaneously remote controllers A and B. In this mode, both remote controllers have equal control
of the aircraft. The roles of both remote controllers operating the aircraft are not assigned in advance.
Instead, either pilot may gain control of the aircraft or the gimbal camera as needed, allowing for more
exibility during the operation.
Control over the aircraft is independent of control over the gimbal camera. When a remote controller
gains control of the aircraft or the gimbal camera, the user can use the controller to operate the aircraft
or control the movement of the gimbal camera respectively.
Setting the Advanced Dual Operator Mode
Before using Advanced Dual Operator mode, the pilot needs to link the aircraft with both remote
controllers A and B. Follow the steps below to link the remote controllers.
1. Run the DJI Pilot 2 app.
2. Enter the homepage and tap Remote Controller A/B to activate linking. During linking, the status LED
of the remote controller will blink blue and the remote controller will beep. Press and hold the power
button on the aircraft for at least ve seconds. The aircraft power indicator will blink and beep twice
to indicate that linking has started. When linking is successful, the aircraft rear indicators will blink
green, the remote controller beep twice, and the remote controller status LED turn solid green.
3. Thereafter, the aircraft control button on the remote controller with control of the aircraft will turn
green, and the aircraft control button of the other remote controller will turn white. Tap on the
upper right corner of the gimbal camera view in DJI Pilot 2 to gain control of the gimbal camera.
Link the two remote controllers one by one. Make sure to link the remote controller A with the
aircraft rst, and then link the remote controller B.
To Next Page
Loading...
Need help?
General
