dji M30 T User Manual

71
©
2022 DJI All Rights Reserved.
MATRICE 30 SERIES User Manual
Using Advanced Dual Operator Mode
1. Make sure both remote controllers are linked and connected with the aircraft before using Advanced
Dual Operator mode. By default, the rst remote controller connected with the aircraft is granted
control of both the aircraft and the gimbal camera, while the second remote controller is not given
any control.
2. When a remote controller has control of a device, whether it is the aircraft or the gimbal camera,
the pilot can control the device by pushing the control sticks, turning the dial, pressing the shortcut
buttons, or tapping the app’s user interface. The operation is the same as in Single Operator mode.
However, when a remote controller does not have control of a device, the pilot is unable to control
the device. Only the remote controller with aircraft control can be used to start or cancel RTH.
3. Either pilot can take over control of a device as needed. Press the aircraft control button to gain
control of the aircraft. Tap on the upper right corner of the gimbal camera view in DJI Pilot 2 to
gain control of the gimbal camera. After gaining aircraft control, the pilot can lock it by pressing and
holding the aircraft authority button on the remote controller. The aircraft authority button will turn
blue when the control is locked. The control sticks are used for operating the gimbal if the remote
controller only has control over the gimbal camera. When the remote controller has full control, the
control sticks are used for controlling the aircraft and the dials for adjusting gimbal movement.
4. In Advanced Dual Operator mode, a control transfer mechanism will be triggered if one of the
remote controllers is disconnected from the aircraft. When this happens, control of the gimbal
camera will shift from the disconnected remote controller to the other remote controller still
connected with the aircraft. If the disconnected remote controller also has aircraft control, the other
remote controller will receive a notication that the user may manually take over aircraft control. If
the pilot of the connected remote controller chooses not to take over aircraft control, the aircraft
will automatically perform the failsafe action. If the pilot of the connected remote controller does not
choose either option within a specied time period, the aircraft will also activate the failsafe action.
5. If the disconnected remote controller reconnects with the aircraft during the ight, it will not resume
its previous control and will by default have no control of any device. The pilot may gain control of
the devices again as needed.
6. Only the remote controller with control of the gimbal camera can be used to adjust relevant settings
for the gimbal and camera, and to download or play back media les.
7. Only the remote controller with the control over gimbal camera can perform the download and
playback operations of the gimbal camera.
8. Under normal circumstances, the pilots of both remote controllers can adjust ight-related settings,
such as for the ight controller system, vision systems, batteries, and video transmission. However,
if aircraft control is locked, only the remote controller with aircraft control can be used to adjust
these settings.
9. Other non ight-related operations can be performed using either remote controller.
10. The pilot of remote controller B cannot adjust settings for network RTK or custom network RTK.
11. Remote controller A can be used to update the rmware of all modules at once when connected
with the aircraft, but remote controller B can only be used to update the firmware of remote
controller B.
12. Uploading Logs Using DJI Pilot 2: The pilot can upload the logs of both the aircraft and remote
controller A through remote controller A, and can upload the logs of remote controller B through
remote controller B.
13. Remote controller B cannot be used to update the GEO Zone database.

dji M30 T Specifications

General

Brand	dji
Model	M30 T
Category	Drones
Language	English