Simga2N Traction Advanced Manual– V1.3 Page 59 (166) ©2021 DMC GmbH Herten Germany
M1.4-9 Speed limit action ramp time “SpLimTim”
This parameter is active only if torque mode is selected (“M2-1 Control Mode “Spd/Torq”” = 1, 2 or 3) and
“Speed limit tolerance” is set greater than zero.
It sets the time taken for speed limitation to become active when the speed reaches the limitation.
To have a good drive feeling it is suggested to set this parameter between 0.2s and 0.05s. Too large values
make the speed limitation unstable and provoking overshoots. Too small values make speed limitation fast but
more aggressive.
To Next Page
Loading...
