DMC Sigma2N - DMC Igauge

Simga2N Traction Advanced Manual– V1.3 Page 160 (166) ©2021 DMC GmbH Herten Germany
10.3 DMC iGauge
The iGauge is a 52mm diameter indicator.
It is capable of indicating lead acid battery discharge state, hours counter and the main SuperSigma2N fault messages.
The iGause is communicating with a DMC SuperSigma2N Controller through the UART protocol.
To this means, it must be wired as in the following picture and plugged into the “Connector B - Communications - 8
Way” on top of the DMC superSigma2N Controller.
Connector B (8-Way)
Tx
C AN L
1 N/C
12V S upply ( +)
7
Rx
5
2
C AN H
0V Supply ( -)
4
Tx - F lash
4
6
+12V Flas h3
+12V
iGauge Connector
8
2
0V
R x - Flas h
3
1