Simga2N Traction Advanced Manual– V1.3 Page 120 (166) ©2021 DMC GmbH Herten Germany
Menu 7 “CAN Bus Setup”
The Simga2N Controller comes with a fully standard CAN Open protocol for sending and receiving information to and
from other CAN nodes.
It is highly advisable to refer to the proper Application Note [1].
For the sake of simplicity, only the basic CAN parameters will be described in this section.
Detailed information about CAN Open protocol will be provided on request.
As default the CAN system is deactivated.
The following sub-menus are available:
• Menu 7.1 “CAN general”
• Menu 7.2 “PDO premap”
• Menu 7.3 “Shared line contactor”
• Menu 7.4 “Display”
• Menu 7.5 “Safe Stop 1”
To Next Page
Loading...
