DMC Sigma2N - About this Manual; References; Navigate into DMC Manuals

To Next Page

To Previous Page

1 About this manual

This manual can be used for a better understanding of controller’s features, installation, settings and parameters. A

detailed description of every parameter is reported. This manual is referred to software release V03.00.08 for AC, PMS

and IPM motors traction application.

1.1 References

[1] Sigma2N Advanced CAN Open manual V1.3

[2] DMC Display manual V1.1

[3] Sigma2N - Dual motor functionalities V1.1

[4] Sigms2N AC Manual V1.2

[5] Sigms2N PMS Manual V1.1

[6] Sigms2N IPM Manual V1.2

[7] AN 220920 - Flash procedure with STM32 Cube Programmer V1.1

[8] DMC Configurator user manual V1.6

[9] Sigma2N BMS support V1.2

1.2 Navigate into DMC manuals

DMC manuals are structured with a hierarchical approach. The milestone for setting up a controller and the general

overview is given in the “Application manuals”, whose embed a comprehensive description of the DMC

Simga2Nfeatures, hardware configuration, parameters menu structure and monitoring possibilities. The “Motor

technology” manuals should be used aside of the “Application manuals” to go further in details about configurable

motor parameters and to run the autotuning procedure.

If the Dual Motor function is required, the user should refer to the “Dual Motor manual” for a deeper level of detail

about the vehicle configuration capabilities. DMC also provides a set of setup manuals for basic Dual Motor parameters

to be configured in the two controller used for running this function.

If then the controller needs to operate in a CAN environment, the user should refer to the “CAN protocol” manual of

interest, which will guide trough the CAN-related parameters and functions available.

Related product manuals