DMC SuperSigma2 - M3-33 T Calibration Data Option Calvalue; M3-34 T Loading Default Loaddefs

SuperSigma2 AM PMS – V1.5.6 17-1-2020 Page 57 (97) ©2019 DMC GmbH Herten Germany
M3-33T Calibration Data option “CalValue”
Not used yet. For future development
M3-34T Loading Default ”LoadDefs”
If this parameter is set to 1 (load defaults) all the setting in all menus will be restored to the default factory values.
This parameter requires a key cycle off-on to be effective.