(3) Install parking brake shoes in caliper (Inboard
and outboard shoes are identical).
(4) Position anti-rattle spring and slide retaining
pin through anti-rattle spring and shoes (Fig. 75).
(5) Using a drift punch, continue to install retain-
ing pin into caliper until snap ring on end of retain-
ing pin is fully seated in outboard side of caliper.
(6) Install hair pin in brake shoe retaining pin
(Fig. 75).
(7) Install parking brake caliper on knuckle (Fig.
63). Install brake caliper mounting bolts. Tighten
upper mounting bolt to 32 N·m (24 ft. lbs.) torque.
Tighten lower mounting bolt to 52 N·m (38 ft. lbs.)
torque.
(8) Install wheel and tire assembly (Refer to 22 -
TIRES/WHEELS - INSTALLATION). Progressively
tighten wheel mounting nuts in proper sequence to
122 N·m (90 ft. lbs.) torque.
(9) Lower vehicle.
(10) Cycle parking brake several times to adjust.
Fig. 72 Shoe Retaining Pin Removal
1 - PIN PUNCH
2 - RETAINING PIN
Fig. 73 Parking Brake Caliper Mounting
1 - KNUCKLE
2 - ROTOR
3 - PARKING BRAKE CALIPER
4 - LOWER MOUNTING BOLT
5 - UPPER MOUNTING BOLT
Fig. 74 Using Piston Retractor To Seat Piston In
Bore
1 - UPPER BUSHING
2 - LOWER BUSHING
3 - PISTON RETRACTOR 6366
Fig. 75 Anti-Rattle Spring Installed Properly
1 - RETAINING PIN
2 - BRAKE SHOES
3 - HAIR PIN
4 - ANTI-RATTLE SPRING
ZB BRAKES - BASE 5 - 45
PADS/SHOES - PARKING BRAKE (Continued)
To Next Page