Dodge ZB 2005 - Page 755

(6) Install the headlamp washer nozzle covers
(Refer to 8 - ELECTRICAL/WIPERS/WASHERS/
WASHER NOZZLE - INSTALLATION).
FRONT BUMPER
REINFORCEMENT
REMOVAL
(1) Remove the fascia. (Refer to 13 - FRAME &
BUMPERS/BUMPERS/FRONT FASCIA -
REMOVAL)
(2) Remove the bolts and remove the hood release
handle. (Fig. 5)
(3) Remove the nuts and remove the reinforce-
ment. (Fig. 2)
INSTALLATION
(1) Install the reinforcement and install the nuts.
(2) Tighten the nuts to 54 N·m (40 ft. lbs.).
(3) Install the hood release handle and install the
bolts.
(4) Install the front fascia. (Refer to 13 - FRAME
& BUMPERS/BUMPERS/FRONT FASCIA - INSTAL-
LATION)
Fig. 4 FRONT FASCIA
1 - PUSH ON SPRING NUT
2 - FRAME ASSEMBLY
3 - RIVET NUT
4 - NUT
5 - BOLTS
6 - BUMPER REINFORCEMENT
7 - FRONT FASCIA
8 - FRONT BUMPER
9 - SQUARE NECK BOLT
Fig. 5 HOOD LATCH RELEASE HANDLE
1 - HOOD REMOTE RELEASE ASSEMBLY
2 - FRONT BUMPER REINFORCEMENT
13 - 4 FRAME & BUMPERS ZB
FRONT FASCIA - EXPORT (Continued)