Dodge ZB 2005 - Page 759

FRONT TOW EYE BRACKET -
EXPORT
REMOVAL - EXPORT
(1) Remove the front fascia (Refer to 13 - FRAME
& BUMPERS/BUMPERS/FRONT FASCIA -
REMOVAL).
(2) Remove the front bumper reinforcement (Refer
to 13 - FRAME & BUMPERS/BUMPERS/FRONT
BUMPER REINFORCEMENT - REMOVAL).
(3) Remove the U-bolts and retaining nuts (Fig.
13).
(4) Remove the tow eye bracket from the frame
(Fig. 13).
INSTALLATION - EXPORT
(1) Install the tow eye bracket to the frame and
install the U-bolts (Fig. 13). Torque the U-bolt nuts
to 12 N·m (9 ft. lbs.).
(2) Install the front bumper reinforcement (Refer
to 13 - FRAME & BUMPERS/BUMPERS/FRONT
BUMPER REINFORCEMENT - INSTALLATION).
(3) Install the front fascia (Refer to 13 - FRAME &
BUMPERS/BUMPERS/FRONT FASCIA - INSTAL-
LATION).
BRACKET - REAR LICENSE
PLATE EXPORT
REMOVAL - EXPORT
(1) Remove the license plate.
NOTE: Lift the license plate flap up to access the
screws.
(2) Remove the 4 screws and the license plate
bracket (Fig. 14).
INSTALLATION - EXPORT
(1) Position the rear license plate bracket and
install the 4 screws (Fig. 14).
(2) Lower the flap and install the license plate.
Fig. 13 TOW EYE BRACKET
1 - U-BOLTS
2 - TOW EYE BRACKET
3-TOWEYE
Fig. 14 REAR LICENSE PLATE BRACKET
1 - BOLTS
2 - LICENSE PLATE BRACKET
13 - 8 FRAME & BUMPERS ZB