Dodge ZB 2005 - Page 758

REAR BUMPER FOAM
REMOVAL
(1) Remove the rear fascia. (Refer to 13 - FRAME &
BUMPERS/BUMPERS/REAR FASCIA - REMOVAL)
(2) Remove the push pin fasteners and remove the
foam (Fig. 11).
INSTALLATION
(1) Install the foam and install the push pin fas-
teners.
(2) Install the rear fascia. (Refer to 13 - FRAME &
BUMPERS/BUMPERS/REAR FASCIA - INSTALLA-
TION)
REAR BUMPER
REMOVAL
(1) Remove the rear bumper foam. (Refer to 13 -
FRAME & BUMPERS/BUMPERS/REAR BUMPER
FOAM - REMOVAL)
(2) Remove the bumper nuts and remove the
bumper beam. (Fig. 12)
INSTALLATION
(1) Install the bumper beam and install the nuts.
(2) Tighten the nuts to 54 N·m (40 ft. lbs.).
(3) Install the rear bumper foam. (Refer to 13 -
FRAME & BUMPERS/BUMPERS/REAR BUMPER
FOAM - INSTALLATION)
Fig. 12 FASCIA REAR BUMPER
1 - FRAME ASSEMBLY
2 - SQUARE NECK BOLT
3 - ROUND SPRING NUT
4 - BUMPER REINFORCEMENT
5 - NUTS
6 - FASCIA REAR BUMPER
Fig. 11 REAR BUMPER FOAM
1 - BODY ASSEMBLY
2 - PUSH PIN
3 - REAR BUMPER
ZB FRAME & BUMPERS 13 - 7