Place the assembly profile (1) with spindle on the outside of the door so that
the spindle is seated in the spindle hub.
Insert the three short screws (2) through the guide slots into the screw
attachment points on the door.
If necessary, move the short screws in the guide slots until they can be
inserted easily into the screw attachment points.
Press the assembly profile onto the door leaf.
Tighten the three short screws so they are hand tight.
Check the lever handle for ease of movement.
Release the centre short screw a little if the lever handle does not move
easily.
Check the lever handle for ease of movement once again.
Fit the assembly profile on the inside onto the door leaf in the same way.
It is possible to damage the surface of the lever handle when
fitting the cover.
Do not use any force when installing the covers of handles.
Twist the cover round the lever handle while fitting in order
to avoid contact.
Ensure that the cover and the lever handle do not touch
when fitting the cover.
To Next Page
Loading...