It is possible to damage the surface of the lever handle when
fitting the cover.
Do not use any force when installing the covers of handles.
Twist the cover round the lever handle while fitting in order
to avoid contact.
Ensure that the cover and the lever handle do not touch
when fitting the cover.
The cover of the mechanical handle is only put loosely in place on delivery.
You must press the cover onto the assembly profile until it clicks audibly into
place.
Distortion of the cover possible due to forceful pressing.
Press the cover carefully until it clicks into the locking
points.
Use the heel of the hand to strike the outer edge of the
cover lightly if necessary.
To Next Page
Loading...